Hydraulic brake hoses

1. Basic parameters

Specifications and models: φ3.2×10.5mm

Material structure: Inner layer: EPDM rubber (oil and corrosion resistant); Middle layer: polyester thread braided reinforcement; Outer layer: EPDM rubber protective layer (wear-resistant and weather-resistant).

2. Performance parameters(according to the inspection report data of the National Motor Vehicle Product Quality Inspection and Testing Center)

Swelling Characteristics:

Maximum expansion capacity: 6.9MPa: 0.40mL/m; 10.3MPa：0.55mL/m; 20.0MPa：1.34mL/m.

Burst Strength:

Blasting strength: 84.2MPa without bursting.

Dynamic Durability:

Bending fatigue: No damage after 35 hours of bending.

High temperature pulse resistance: 73.2MPa without bursting.

Mechanical Properties:

Mechanical strength: slow speed: 2747.8N joint pull-out; Quick 2812.6N connector pull off.

3. Environmental adaptability

Water absorption: 83.4MPa without bursting; After 35 hours of bending, there was no damage;

Cold resistance: After the test, there are no visible cracks on the inner and outer surfaces of the hose;

Ozone resistance: After the test, under a seven fold magnifying glass, there were no visible cracks on the surface of the hose;

Resistance to dynamic ozone: After the test, there were no visible cracks or fissures observed by the naked eye;

Corrosion resistance of joints: Metal substrate is non corrosive.

4、application adaptation

Applicable scenarios: hydraulic braking system for motorcycles, cars, and light vehicles.

Supporting standards: in line with CQC, DOT, SAE J1401 certification requirements.

 Joint compatibility: Support metric, American, and imperial threaded joint customization.